There are a few things you need to know in order to properly configure the Enttec USB PRO Box for it to work properly with ESP Vision.
This discussion is valid for the following configurations:
Windows 7 64-bit to Vision 2.3 PC using Enttec USB PRO Box
Windows 7 32-bit to Vision 2.3 PC using Enttec USB PRO Box
Windows XP to Vision 2.3 PC using Enttec USB PRO Box
Windows Vista ro Vision 2.3 PC using Enttec USB PRO Box
Installing Enttec USB PRO Drivers:
**If using Windows XP, Windows Vista, or Windows 7 32-bit, the drivers should already be installed through the operating system. If running on Windows 7 64-bit, then follow the steps below.
To begin, connect the USB PRO Box to the Windows 7 64-bit machine. Insert the Enttec disc and select the drivers option. Make sure to select the D2XX driver. After installing this driver, launch ESP Vision 2.3 PC.
When Vision launches, change the DMX Provider to USB PRO. A dialog box will open up. In the dialog box, select the USB PRO Box's serial number in the universes you wish to use.
Now, you should be able to patch your show (or load an existing show), and you should be good to go.
If you continue to have issues, or questions, contact ESP Vision Support by phone, Live Chat, email or by posting to the forum.
How to configure DMX from different sources to Vision
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests